HEADLIGHT CLEANER ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight washer actuator sub-assembly removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera view adjustment Panoramic view monitor system

Click here

Note

Be sure to read the "PRECAUTION" thoroughly before servicing (w/ Air Suspension).

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. except Sport Package

      Click here

    2. for Sport Package

      Click here

  2. REMOVE HEADLIGHT WASHER COVER LH

    Click here

  3. REMOVE HEADLIGHT WASHER COVER RH

    Tech Tips

    Use the same procedure for the RH and LH sides.

  4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


    1. B006ANDC01
      B006DHE Remove in this Direction

      Detach the claw and disconnect the No. 1 headlight cleaner hose as shown in the illustration.

    2. B006D65

      Remove the screw.

    3. Press part A, detach the claw and guide and remove the headlight washer actuator sub-assembly LH as shown in the illustration.

      B006E2NC01
      *a A - -
      B006DHE Remove in this Direction(1) B006B42 Remove in this Direction(2)
    4. B006BGKC01
      B006DHE Remove in this Direction

      Remove the spring nut from the headlight washer actuator sub-assembly LH.

  5. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH and LH sides.

  6. REMOVE NO. 2 WASHER BRACKET

    B006AUBC72
    *a Heated Part
    *b Heat Light

    1. Using a heat light, heat the No. 2 washer bracket.

      CAUTION:


      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

      Tech Tips

      20 to 30°C for 3 to 5 minutes.

    2. B006CKX

      Remove the No. 2 washer bracket.

  7. REMOVE WASHER BRACKET

    Tech Tips

    Use the same procedure described for the No. 2 washer bracket.

  8. REMOVE NO. 1 HEADLIGHT CLEANER HOSE

    Click here