FRONT DRIVE SHAFT ASSEMBLY(for 1ZR-FE, 2ZR-FE) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE FRONT WHEELS

2. REMOVE NO. 1 ENGINE UNDER COVER

3. REMOVE REAR ENGINE UNDER COVER LH

4. REMOVE REAR ENGINE UNDER COVER RH

5. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID (for CVT)

   Click here

6. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle)

   Click hereClick here

7. REMOVE FRONT AXLE SHAFT NUT

   1. 

      Using SST and a hammer, release the staked part of the front axle shaft nut.

      09930-00010

      Note:

      Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

   2. While applying the brakes, remove the front axle shaft nut.

8. SEPARATE FRONT SPEED SENSOR

   Click hereClick here

9. SEPARATE FRONT FLEXIBLE HOSE

   Click hereClick here

10. SEPARATE TIE ROD END SUB-ASSEMBLY

    Click here

11. SEPARATE FRONT STABILIZER LINK ASSEMBLY

    Click here

12. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

    Click hereClick here

13. SEPARATE FRONT DRIVE SHAFT ASSEMBLY

    Click hereClick here

14. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    1. 

       Using SST, remove the front drive shaft assembly LH.

       09520-01010

       09520-24010

       09520-32040

       Note:

       • Do not damage the CVT type T oil seal LH (for CVT).

       • Do not damage the transmission case oil seal (for Manual Transaxle).

       • Do not damage the front axle inboard joint boot.

       • Do not drop the front drive shaft assembly LH.

15. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Tip:

    Perform the same procedure as for the LH side.

16. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING

    1. 

       Using a screwdriver, remove the front drive shaft hole snap ring.