RELAY ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT STARTER RELAY (ST)

    1. B453701E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the starter relay.

  2. INSPECT ACC RELAY (ACC)

    1. B453701E02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the ACC relay.

  3. INSPECT GLOW RELAY

    1. A337020

      Remove the bolt.

    2. Disconnect the connector and remove the glow relay.

    3. A201709E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      1 - 2

      Battery voltage not applied to terminals 3 and 4

      10 kΩ or higher

      Battery voltage applied to terminals 3 and 4

      Below 1 Ω

      If the result is not as specified, replace the glow relay.

    4. Connect the connector.

    5. Install the glow relay with the bolt.

      18 N*m

      178 kgf*cm

      13 ft.*lbf