AIRBAG CUT-OFF SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.

    3. Attach the 2 claws to install the airbag cutoff switch cylinder sub-assembly.

  2. INSTALL INSTRUMENT SIDE PANEL

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here