OIL PAN REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transaxle oil (CVT) pan sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID


    1. A001X15

      Remove the refill plug and gasket from the rear transaxle case.

    2. A001X5M

      Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle oil (CVT) pan sub-assembly and drain the fluid.

    3. A001WMHC01
      *1 No. 1 Transmission Oil Filler Tube

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly and drain the fluid.

    4. Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

    5. Using a 6 mm hexagon socket wrench, temporarily install the overflow plug and gasket to the transaxle oil (CVT) pan sub-assembly.

      Tech Tips

      Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.

    6. Temporarily install the refill plug and gasket to the rear transaxle case.

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.

  4. REMOVE TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY


    1. A001WVQ

      Remove the 16 bolts, transaxle oil (CVT) pan sub-assembly and transaxle oil pan (CVT) gasket from the transaxle case.

    2. Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle oil (CVT) pan sub-assembly.

    3. Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly.

  5. REMOVE OIL CLEANER (CVT) MAGNET


    1. A001SI3C01
      *1 Oil Cleaner (CVT) Magnet

      Remove the 3 oil cleaner (CVT) magnets from the transaxle oil (CVT) pan sub-assembly.

    2. Clean off any metal particles adhered to the 3 oil cleaner (CVT) magnets.

    3. Clean the transaxle oil (CVT) pan sub-assembly and remove any metal particles, sludge, etc.