FRONT DRIVE SHAFT ASSEMBLY(for 1NR-FE) COMPONENTS
ILLUSTRATION
*1 |
REAR ENGINE UNDER COVER LH |
*2 |
REAR ENGINE UNDER COVER RH |
ILLUSTRATION
*1 |
FRONT AXLE SHAFT NUT |
*2 |
FRONT DRIVE SHAFT ASSEMBLY LH |
*3 |
FRONT FLEXIBLE HOSE |
*4 |
FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
*5 |
FRONT SPEED SENSOR |
*6 |
FRONT STABILIZER LINK ASSEMBLY |
*7 |
TIE ROD END SUB-ASSEMBLY |
*8 |
FRONT AXLE ASSEMBLY |
*9 |
COTTER PIN |
- |
- |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
 |
Do not apply lubricants |
- |
- |
ILLUSTRATION
*A |
w/ Drive Shaft Damper |
*B |
w/o Drive Shaft Damper |
*1 |
FRONT DRIVE SHAFT ASSEMBLY LH |
*2 |
FRONT DRIVE SHAFT ASSEMBLY RH |
*3 |
FRONT DRIVE SHAFT HOLE SNAP RING |
*4 |
TRANSMISSION CASE OIL SEAL |
*5 |
TRANSAXLE CASE OIL SEAL |
- |
- |
● |
Non-reusable part |
 |
Gear oil |
 |
MP grease |
- |
- |
ILLUSTRATION
*A |
for LH Side |
- |
- |
*1 |
FRONT AXLE INBOARD JOINT BOOT |
*2 |
FRONT AXLE INBOARD JOINT BOOT CLAMP |
*3 |
FRONT AXLE OUTBOARD JOINT BOOT |
*4 |
FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
*5 |
FRONT DRIVE INBOARD JOINT ASSEMBLY |
*6 |
FRONT DRIVE SHAFT DUST COVER |
*7 |
FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
*8 |
FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP |
*9 |
SHAFT SNAP RING |
*10 |
TRIPOD JOINT |
*11 |
FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY |
- |
- |
● |
Non-reusable part |
- |
- |
ILLUSTRATION
*A |
for RH Side |
*B |
w/ Drive Shaft Damper |
*1 |
FRONT AXLE INBOARD JOINT BOOT |
*2 |
FRONT AXLE INBOARD JOINT BOOT CLAMP |
*3 |
FRONT AXLE OUTBOARD JOINT BOOT |
*4 |
FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
*5 |
FRONT DRIVE INBOARD JOINT ASSEMBLY |
*6 |
FRONT DRIVE SHAFT DAMPER RH |
*7 |
FRONT DRIVE SHAFT DUST COVER |
*8 |
FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
*9 |
FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP |
*10 |
SHAFT SNAP RING |
*11 |
TRIPOD JOINT |
*12 |
FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY |
*13 |
FRONT DRIVE SHAFT DAMPER CLAMP |
- |
- |
● |
Non-reusable part |
- |
- |