ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
*1 |
DIFFERENTIAL PRESSURE SENSOR ASSEMBLY |
*2 |
FRONT FLOOR COVER |
*3 |
FRONT FLOOR COVER RH |
*4 |
NO. 1 ENGINE COVER |
*5 |
NO. 1 ENGINE UNDER COVER |
*6 |
REAR ENGINE UNDER COVER LH |
*7 |
REAR ENGINE UNDER COVER RH |
*8 |
VACUUM TRANSMITTING HOSE |
 |
Specified torque: N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
*1 |
FRONT EXHAUST PIPE ASSEMBLY |
*2 |
PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
*3 |
AIR FUEL RATIO SENSOR |
*4 |
WIRE HARNESS CLAMP |
*5 |
TAILPIPE ASSEMBLY |
*6 |
COMPRESSION SPRING |
*7 |
GASKET |
- |
- |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
* |
For use with SST |
● |
Non-reusable part |
 |
Do not apply lubricants |
ILLUSTRATION
*1 |
AIR CLEANER CAP SUB-ASSEMBLY |
*2 |
AIR CLEANER CASE |
*3 |
AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
*4 |
BATTERY |
*5 |
BATTERY BRACKET REINFORCEMENT |
*6 |
BATTERY CLAMP SUB-ASSEMBLY |
*7 |
BATTERY INSULATOR |
*8 |
BATTERY TRAY |
*9 |
NEGATIVE BATTERY TERMINAL |
*10 |
POSITIVE BATTERY TERMINAL |
*11 |
FRONT BATTERY BRACKET |
- |
- |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
*1 |
AIR CLEANER BRACKET |
*2 |
AIR CLEANER SUPPORT |
*3 |
DISCHARGE HOSE SUB-ASSEMBLY |
*4 |
FUEL FILTER ASSEMBLY |
*5 |
FUEL HOSE PROTECTOR |
*6 |
INLET HEATER WATER HOSE |
*7 |
NO. 2 RADIATOR HOSE |
*8 |
NO. 2 WATER BY-PASS HOSE |
*9 |
NO. 3 AIR HOSE |
*10 |
OUTLET HEATER WATER HOSE |
*11 |
SUCTION HOSE SUB-ASSEMBLY |
*12 |
O-RING |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent |
- |
- |
ILLUSTRATION
*1 |
ECM |
*2 |
NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY |
*3 |
RADIATOR HOSE SUB-ASSEMBLY |
*4 |
RADIATOR RESERVOIR ASSEMBLY |
*5 |
ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK COVER |
*6 |
INJECTOR DRIVER ASSEMBLY |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
- |
- |
ILLUSTRATION
*1 |
COLUMN HOLE COVER SILENCER SHEET |
*2 |
FRONT AXLE SHAFT NUT LH |
*3 |
FRONT DRIVE SHAFT ASSEMBLY LH |
*4 |
FRONT DRIVE SHAFT ASSEMBLY RH |
*5 |
FRONT STABILIZER LINK ASSEMBLY LH |
*6 |
NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
*7 |
FRONT SPEED SENSOR LH |
*8 |
TIE ROD END SUB-ASSEMBLY LH |
*9 |
FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH |
*10 |
FRONT DRIVE SHAFT HOLE SNAP RING LH |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
|
MP grease |
|
Do not apply lubricants to the threads |
ILLUSTRATION
*1 |
ENGINE MOUNTING BRACKET LH |
*2 |
ENGINE WITH TRANSAXLE |
*3 |
FRONT SUSPENSION MEMBER REINFORCEMENT LH |
*4 |
FRONT SUSPENSION MEMBER REINFORCEMENT RH |
*5 |
REAR ENGINE MOUNTING INSULATOR |
*6 |
FRONT CROSSMEMBER SUB-ASSEMBLY |
*7 |
FRONT ENGINE MOUNTING INSULATOR |
*8 |
FRONT SUSPENSION MEMBER REAR BRACE RH |
*9 |
FRONT SUSPENSION MEMBER REAR BRACE LH |
*10 |
FRONT SUSPENSION MEMBER SUB-ASSEMBLY |
*11 |
NO. 1 ENGINE HANGER |
*12 |
NO. 2 ENGINE HANGER |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
★ |
Precoated part |
ILLUSTRATION
*1 |
AUTOMATIC TRANSAXLE ASSEMBLY |
*2 |
DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
*3 |
FRONT ENGINE MOUNTING BRACKET |
*4 |
INTERCOOLER AIR HOSE |
*5 |
NO. 1 AIR TUBE |
*6 |
OIL PAN INSULATOR |
*7 |
REAR ENGINE MOUNTING BRACKET |
*8 |
STARTER ASSEMBLY |
*9 |
STIFFENER PLATE LH |
*10 |
STIFFENER PLATE RH |
*11 |
FRONT DRIVE PLATE SPACER |
*12 |
REAR DRIVE PLATE SPACER |
*13 |
TRANSMISSION CONTROL CABLE ASSEMBLY |
- |
- |
*a |
BLACK: x 1 SILVER: x 5 |
- |
- |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
★ |
Precoated part |
- |
- |
ILLUSTRATION
*1 |
ENGINE MOUNTING INSULATOR LH |
*2 |
ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
|
Specified torque: N*m (kgf*cm, ft.*lbf) |
- |
- |