TELEMATICS SYSTEM, Diagnostic DTC:B1583
| DTC Code | DTC Name |
|---|---|
| B1583 | GPS Signal Unreceived |
DESCRIPTION
This DTC is stored when GNSS satellite signals is not received for 30 km.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
B1583 |
GPS Signal Unreceived |
GNSS signals are not received for 30 km. |
|
CAUTION / NOTICE / HINT
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
PROCEDURE
MOVE VEHICLE
If the vehicle is outside the communication service area, move the vehicle into a communication service area, wait for a while and perform the operation again.
Result
Proceed to
NEXT
CHECK DTC
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK
No DTCs are output.
Result
Proceed to
OK
NG
CHECK OPTIONAL COMPONENTS
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
Result
Result
Proceed to
Optional components are not installed
A
Optional components are installed
B
Note:Do not remove optional components without the permission of the customer.
B REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)
CHECK DTC OUTPUT
Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Navigation System > Trouble Codes
Result
Result
Proceed to
No DTCs are output.
A
DTC B1583 is output.
B
A END
INSPECT TELEPHONE ANTENNA CORD SUB-ASSEMBLY
Result
Proceed to
OK
NG
INSPECT NO. 1 AMPLIFIER ANTENNA ASSEMBLY
Result
Proceed to
OK
NG
INSPECT ANTENNA CORD SUB-ASSEMBLY
Result
Proceed to
OK
NG
INSPECT INSTRUMENT PANEL WIRE
Result
Proceed to
OK
NG
NG REPLACE INSTRUMENT PANEL WIRE
REPLACE TELEPHONE ANTENNA ASSEMBLY
Replace the telephone antenna assembly with a new or known good one.
Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
Recheck for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK
No DTCs are output.
Result
Proceed to
OK
NG
OK END
REPLACE TELEMATICS TRANSCEIVER
Replace the telematics transceiver with a new one.
Result
Proceed to
NEXT