MASS AIR FLOW METER ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Note


  • Perform the mass air flow meter sub-assembly inspection according to the following procedure.

  • Only replace the mass air flow meter sub-assembly when the mass air flow meter sub-assembly value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter sub-assembly platinum hot wire (heater).

PROCEDURE


  1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

    Note


    • Perform the inspection with the vehicle indoors and on a level surface.

    • Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

    • During this inspection, do not use an exhaust air duct on the exhaust pipe.

    Tech Tips

    Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

    Click here


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG) (do not start the hybrid system).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.


      Powertrain > Engine and ECT > Data List
      Tester Display
      MAF

    5. Wait for 30 seconds, and then read the Date List according to the display on the GTS.

      Standard Condition
      Item Condition Specified Condition
      MAF

      • Engine not running

      • 30 seconds after turning power switch on (IG)

      		 0.57 gm/sec or less

      If the result is not as specified, replace the mass air flow meter sub-assembly.

      If the result is as specified, inspect the mass air flow meter sub-assembly.

      Click here

  2. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

      Click here