HYBRID TRANSAXLE SYSTEM ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT TRANSAXLE FLUID PRESSURE

    Note

    Perform the test at normal operating transaxle fluid temperature 50 to 80°C (122 to 176°F).


    1. Remove the rear engine under cover LH.

    2. Lift up the vehicle.

    3. Remove the fluid pump cover plug and O-ring.

    4. A005BHZ

      Install an oil pressure gauge with the adapter.

    5. Put the engine in inspection mode Click here.

    6. Measure the transaxle fluid pressure.

      Standard
      Engine Speed Transaxle Fluid Pressure
      1000 rpm

      3 kPa (0.03 kgf/cm2, 0.4 psi) or more

      Note

      Be sure to cancel inspection mode immediately after the transaxle fluid pressure check is completed.

    7. A005E3J

      Install a new O-ring and fluid pump cover plug.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    8. Install the rear engine under cover LH.