POWER MIRROR CONTROL SYSTEM

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result

   Proceed to
   NEXT

   NEXT

2. INSPECT BATTERY VOLTAGE

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

   NEXT

3. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

   1. Use the intelligent tester to check if the LIN communication system is functioning normally.

      Result

      Result	Proceed to
      LIN DTC is not output	A
      LIN DTC is output	B

   B

   GO TO LIN COMMUNICATION SYSTEM

   Click here

   A

4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

   1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Click here

      Result

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B

   GO TO CAN COMMUNICATION SYSTEM

   Click hereClick here

   A

5. PROBLEM SYMPTOMS TABLE

   1. Refer to Problem Symptoms Table.

      Click here

      Result

      Result	Proceed to
      Fault is not listed in Problem Symptoms Table	A
      Fault is listed in Problem Symptoms Table	B

   B

   REPAIR OR REPLACEClick here

   A

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

   1. Operation Check.

      Click here

   2. Data List / Active Test.

      Click here

   3. Terminals of ECU.

      Click here

      Result

      Proceed to
      NEXT

   NEXT

7. REPAIR OR REPLACE

   Result

   Proceed to
   NEXT

   NEXT

8. CONFIRMATION TEST

   Result

   Proceed to
   NEXT

   NEXT

   END