REAR FLOOR AIRBAG SENSOR REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting timemay be required before disconnecting the cablefrom the battery terminal. Therefore, make sure toread the disconnecting the cable from the batteryterminal notice before proceeding with work (Click hereClick hereClick here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  2. REMOVE REAR NO. 1 SEAT ASSEMBLY

    1. for 60/40 Split Double-folding Seat Type LH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

    2. for 60/40 Split Double-folding Seat Type RH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

    3. for 60/40 Split Slide Walk-in Seat Type LH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

    4. for 60/40 Split Slide Walk-in Seat Type RH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

  3. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click hereClick here

  4. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click hereClick here

  5. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

    Click hereClick here

  6. REMOVE REAR DOOR SCUFF PLATE LH

    Click hereClick here

  7. REMOVE REAR DOOR SCUFF PLATE RH

    Click hereClick here

  8. REMOVE REAR FLOOR SIDE AIRBAG SENSOR COVER

    1. Fold back the floor carpet.

    2. B238364

      Detach the clip and claw and remove the cover.

  9. REMOVE REAR FLOOR SIDE AIRBAG SENSOR

    1. B238365

      Remove the bolt and sensor.

    2. Disconnect the connector.