WHEEL OPENING MOULDING(for Rear) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

    Tech Tips

    When removing the quarter outside moulding sub-assembly LH, if the No. 5 moulding tape(double-sided tape) is difficult to remove, heat the adhesive of the quarter outside moulding sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Quarter Outside Moulding Sub-assembly LH 40 to 60°C (104 to 140°F)

    Note

    Do not heat the quarter outside moulding sub-assembly LH excessively.


    1. A01HHRIC01
      *1 Screw

      Remove the 3 clip.

    2. Using a 4 mm hexagon socket wrench, remove the hexagon screw.

    3. A01HI7GC01
      *1 Protective Tape

      Put protective tape around the quarter outside moulding sub-assembly LH.

    4. Detach the 3 clips and 4 claws and remove the quarter outside moulding sub-assembly LH.

      A01HJO8C01
      *1 No. 5 Moulding Tape (Double-sided Tape) - -
      B008IUL Direction to Pull - -