REMOTE TOUCH INSTALLATION

PROCEDURE

1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY

   
   

   1. w/o Navigation System

      
      

      1. Install the remote operation controller assembly with the 4 bolts.

   2. w/ Navigation System

      
      

      1. Install the remote operation controller assembly with the 4 bolts.

2. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

   Click here

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

5. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

6. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

7. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

9. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

10. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

11. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

12. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

13. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

14. INSTALL UPPER REAR CONSOLE PANEL

    Click here

15. INSTALL CONSOLE ARMREST ASSEMBLY

    Click here

16. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

    Click here

17. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here