BACK DOOR COURTESY SWITCH INSPECTION

PROCEDURE

1. INSPECT BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)

   1. 

      *a	Component without harness connected (Back Door Lock Assembly (Back Door Courtesy Switch))
      *b	Clockwise
      *c	Counterclockwise
      *d	Drive Gear
      *e	Over-latch
      *f	Full-latch
      *g	Half-latch
      *h	Open-latch

      w/ Power Back Door:

      1. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

         OK

         Condition	Specified Condition
         Battery positive (+) → Terminal 1 (M+) Battery negative (-) → Terminal 2 (M-)	Latch turns to full-latch position (clockwise rotation)
         Battery positive (+) → Terminal 2 (M-) Battery negative (-) → Terminal 1 (M+)	Latch turns to open-latch position (counterclockwise rotation)

      2. Measure the resistance according to the value(s) in the table below.

         Standard Resistance

         Tester Connection	Condition	Specified Condition
         3 (CTY) - 4 (E)	Over-latch	10 kΩ or higher
         3 (CTY) - 4 (E)	Full-latch	10 kΩ or higher
         3 (CTY) - 4 (E)	Half-latch	10 kΩ or higher
         3 (CTY) - 4 (E)	Open-latch	Below 1 Ω

         If the result is not as specified, replace the back door lock assembly (back door courtesy switch).

   2. 

      *a	Component without harness connected (Back Door Lock Assembly (Back Door Courtesy Switch))
      *b	Unlock
      *c	Lock

      w/o Power Back Door:

      1. Move the back door lock assembly to the lock position.

      2. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

         OK

         Condition	Specified Condition
         Battery positive (+) → Terminal 2 (ACT+) Battery negative (-) → Terminal 1 (ACT-)	Unlock

      3. Measure the resistance according to the value(s) in the table below.

         Standard Resistance

         Tester Connection	Condition	Specified Condition
         3 (D+) - 1 (ACT-)	Lock	10 kΩ or higher
         3 (D+) - 1 (ACT-)	Unlock	Below 1 Ω

         If the result is not as specified, replace the back door lock assembly (back door courtesy switch).