REAR FLOOR AIRBAG SENSOR REMOVAL

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE REAR NO. 1 SEAT ASSEMBLY

    1. for 60/40 Split Slide Walk-in Seat Type LH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

    2. for 60/40 Split Slide Walk-in Seat Type RH Side:

      1. Remove the rear No. 1 seat assembly (Click here).

  3. REMOVE REAR NO. 1 FLOOR STEP COVER

    Click here

  4. REMOVE QUARTER SCUFF PLATE LH

    Click here

  5. REMOVE QUARTER SCUFF PLATE RH

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  7. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  8. REMOVE REAR FLOOR SIDE AIRBAG SENSOR COVER

    1. Fold back the floor carpet.

    2. B238364

      Detach the clip and claw and remove the cover.

  9. REMOVE REAR FLOOR SIDE AIRBAG SENSOR

    1. B238365

      Remove the bolt and sensor.

    2. Disconnect the connector.