ДАТЧИК МАССОВОГО РАСХОДА ВОЗДУХА СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of mass air flow meter sub-assembly Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE MASS AIR FLOW METER SUB-ASSEMBLY


    1. B006NHF

      Disconnect the mass air flow meter sub-assembly connector.

    2. Remove the 2 screws and mass air flow meter sub-assembly from the air cleaner cap sub-assembly.

      Note

      If the mass air flow meter sub-assembly has been struck or dropped, replace it.