WHEEL OPENING MOULDING(for Rear) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE NO. 5 MOULDING TAPE


    1. A01HIHB

      Remove the No. 5 moulding tape (double-sided tape).

      Tech Tips

      Do not pull on the No. 5 moulding tape (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.

      A01HJJC

    2. Using non-residue solvent and a cloth, wipe off any No. 5 moulding tape (double-sided tape) remaining on the quarter outside moulding sub-assembly LH.

  2. REMOVE REAR LOWER QUARTER MOULDING PROTECTOR LH


    1. A01HDV0

      Remove the rear lower quarter moulding protector LH (double-sided tape).

      Tech Tips

      Do not pull on the rear lower quarter moulding protector LH (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.

      A01HJJC

    2. Using non-residue solvent and a cloth, wipe off any rear lower quarter moulding protector LH (double-sided tape) remaining on the quarter outside moulding sub-assembly LH.