OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENSOR

   1. Coat the O-ring of the pressure sensor with Toyota Genuine CVT fluid FE.

   2. 

      *a	Length of SST 50 mm (1.97 in.)
      *b	Length of Torque Wrench 180 mm (7.09 in.)

      Using SST, install the oil pressure sensor.

      09326-22011

      without SST

      21 N*m

      214 kgf*cm

      15 ft.*lbf

      with SST

      16 N*m

      163 kgf*cm

      12 ft.*lbf

      Note:

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum lengthof 50 mm (1.97 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click hereClick hereClick hereClick here

   3. Connect the oil pressure sensor connector.

2. INSTALL REAR ENGINE UNDER COVER LH

   Click hereClick here

3. RESET MEMORY

   Click hereClick here