HIGH INTENSITY DISCHARGE HEADLIGHT BULB REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE FRONT BUMPER COVER

  2. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

    E268838
    1. Disconnect the connector.

    2. Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to separate the headlight light control ECU sub-assembly LH from the headlight unit.

      Note:
      • Do not apply excessive force using a tool.

      • Do not damage the headlight gasket or allow it to become contaminated with foreign matter. If the headlight gasket is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly LH.

    3. E268840

      Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to remove the headlight light control ECU sub-assembly LH.

      Note:

      Do not pull the headlight light control ECU sub-assembly LH with the socket connected.

  5. REMOVE HEADLIGHT GASKET

    E268831
    1. Remove the headlight gasket from the headlight light control ECU sub-assembly LH.

  6. REMOVE DISCHARGE HEADLIGHT BULB

    U124029E02
    1. Release the set spring lock in the order shown in the illustration and remove the discharge headlight bulb.

      Note:

      Do not touch the discharge headlight bulb glass.