UNDER BODY TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
Point K, k and L, l on the vehicle are asymmetrical.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Under Cover Installation Nut | M8 (0.31) |
| B, b | Front Bumper Reinforcement Installation Nut | M8 (0.31) |
| C, c | Front Side Member Standard Hole | φ18 (0.71) |
| D, d | Front Suspension Member Installation Nut | M12 (0.47) |
| E, e | Front Spring Support Installation Hole | φ9.5 (0.37) |
| F, f | Front Suspension Member Installation Nut | M12 (0.47) |
| G, g | Sub Frame Installation Nut | M10 (0.39) |
| H, h | Torque Box Standard Hole | φ25 (0.98) |
| J, j | Front Side Member Standard Hole | φ18 (0.71) |
| K, k | Engine Rear Mounting Member Installation Nut | M10 (0.39) |
| L, l | Propeller Shaft Center Support Bearing Installation Nut | M10 (0.39) |
| M, m | Front Floor Reinforcement Standard Hole | φ13 (0.51) |
| N, n | Front Crossmember Side Gusset Standard Hole | φ13 (0.51) |
| O, o | Support Sub Frame Installation Nut | M10 (0.39) |
| P, p | Rear Suspension Member Installation Nut | M14 (0.55) |
| Q, q | Rear Suspension Installation Hole | φ11 (0.43) |
| R, r | Rear Suspension Member Installation Nut | M14 (0.55) |
| S, s | Rear Floor Side Member Standard Hole | φ18 (0.71) |
| Wheel Base | 2570 mm (101.18 in.) |
| *1 | Front |
| *2 | mm |
| *3 | (in.) |
