PARKING ASSIST ECU(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL PARKING ASSIST ECU


    1. B007WPYC01
      B007Z37 Install in this Direction

      Install the parking assist ECU with the 2 nuts as shown in the illustration.

    2. Connect each connector.

    3. B007XTFC01
      B007Z37 Install in this Direction

      Engage the clamp as shown in the illustration.

    4. Install the wire harness protector with the nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    5. Install the bolt.

  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  5. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  7. INSTALL INSTRUMENT PANEL GARNISH RH

    Tech Tips

    Use the same procedure as for the LHD.

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  9. PERFORM INITIALIZATION

    Click here

  10. PERFORM PANORAMIC VIEW MONITOR SYSTEM CALIBRATION

    Click here