REAR SEAT RECLINING CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback lock assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • B0084SX

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

PROCEDURE


  1. REMOVE SPARE WHEEL COVER ASSEMBLY

    Click here

  2. REMOVE REAR SEAT ASSEMBLY

    Click here

  3. REMOVE CENTER STOP LIGHT SET

    Click here

  4. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD


    1. B0083WQ

      Remove the luggage compartment trim inner pad.

  5. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

    Click here

  6. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  8. REMOVE INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  9. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

    Click here

  10. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)


    1. B0088YM

      Remove the 2 clips.

    2. B0085XZ

      Disengage the 3 clips and 5 guides.

    3. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.

  11. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)

    Click here

  12. REMOVE ROOM PARTITION BOARD LH


    1. B0086MJ

      Remove the clip.

    2. B008783

      Disengage the 2 claws.

    3. Disengage the 4 clips to remove the room partition board LH.

  13. REMOVE ROOM PARTITION BOARD RH


    1. B00879B

      Remove the 2 clips.

    2. B0084MT

      Disengage the 5 clips to remove the room partition board RH.

  14. REMOVE REAR SEATBACK LOCK ASSEMBLY LH


    1. B0083COC01
      *a Stopper
      B00888T Release
      B00847Z Remove in this Direction (1)
      B008776 Remove in this Direction (2)

      Release the stopper and disengage the guide as shown in the illustration.

    2. B008859

      Remove the 2 nuts and rear seatback lock assembly LH.

  15. REMOVE REAR SEATBACK LOCK ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.