REMOTE TOUCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

  4. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

    Click here

  5. REMOVE CONSOLE ARMREST ASSEMBLY

    Click here

  6. REMOVE UPPER REAR CONSOLE PANEL

    Click here

  7. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

  8. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

  9. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  10. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  11. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  12. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  13. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  14. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  15. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  16. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  17. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  18. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    Click here

  19. REMOVE REMOTE OPERATION CONTROLLER ASSEMBLY


    1. w/o Navigation System


      1. A01XO3O

        Remove the 4 bolts and remote operation controller assembly.

    2. A01XNUR

      w/ Navigation System


      1. Remove the 4 bolts and remote operation controller assembly.