BACK DOOR CLOSER SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Back Door, Main Body or Entry&Start* / Data List.

      • *: w/ Entry and Start System

    5. According to the display on the GTS, read the Data List.

      Body Electrical > Back Door > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Door Lock Status

      Back door condition signal

      Lock or Unlock

      Lock: Back door locked

      Unlock: Back door unlocked

      -

      Half Latch SW

      Latch switch signal

      ON or OFF

      ON: Back door lock motor open-latched

      OFF: Back door lock motor full-latched or half-latched

      -

      Closer Position SW

      Sector switch signal

      ON or OFF

      ON: Back door lock center gear in center position

      OFF: Back door lock center gear not in center position

      -

      Courtesy SW

      Back door courtesy switch signal

      ON or OFF

      ON: Back door open

      OFF: Back door closed

      -

      IG SW

      Ignition switch signal

      ON or OFF

      ON: Ignition switch ON

      OFF: Ignition switch off

      "OFF" is also displayed for this item when the ignition switch is ACC.

      #Codes

      The number of DTCs

      Min.: 0

      Max.: 255

      The number of DTCs

      -

      Body Electrical > Main Body > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Back Door Open

      Back door condition signal

      Permit or Prohibit

      Permit: Back door unlocked

      Prohibit: Back door locked

      -

      Back Door Open Handle SW

      Back door opener switch assembly signal

      ON or OFF

      ON: Back door opener switch assembly on

      OFF: Back door opener switch assembly off

      -

      Body Electrical > Entry&Start > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Tr/B-Door Lock SW

      Back door opener switch assembly signal

      ON or OFF

      ON: Back door opener switch assembly on

      OFF: Back door opener switch assembly off

      -