CANISTER INSPECTION


  1. INSPECT CHARCOAL CANISTER ASSEMBLY


    1. Check the appearance.


      1. B007WCR

        Visually check the charcoal canister for cracks or damage.

        If necessary, replace the charcoal canister.

    2. Check the charcoal canister filter.


      1. B007R3EE01

        Remove the charcoal canister filter.

      2. B007T0ZE01

        Visually check that the charcoal canister filter is not excessively damaged or dirty.

        If necessary, replace the charcoal canister.

    3. Check the ventilation.


      1. B007P10E01

        Blow air (4.7 kPa (48 gf/cm2, 0.68 psi)) into port A, then check that the air flows from ports B and C.

        If the ventilation is not as specified, replace the charcoal canister.

    4. Clean the filter in canister.


      1. B007QXWE01

        Clean the filter by blowing (19.6 kpa (0.2 kgf/cm2, 2.8 psi)) compressed air into port B while holding port A closed.

        Note


        • Do not attempt to wash the canister.

        • No activated carbon should come out.

    5. Install the charcoal canister filter.