COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  7. REMOVE COMBINATION METER ASSEMBLY

    1. E182624

      Remove the 2 screws.

    2. Detach the clip.

    3. E182625

      Detach the clamp.

    4. Disconnect the connector and remove the combination meter.