EXHAUST PIPE INSTALLATION


  1. INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY


    1. Temporally install the pipe support and clamp with the bolt.

    2. Install a new gasket to the exhaust manifold.

    3. Install the front exhaust pipe to the exhaust manifold with the 3 nuts. Alternately tighten the bolts in several passes.

      Torque:
      62 N*m  { 632 kgf*cm, 46 ft.*lbf }

    4. Install the stay to the transmission with the 2 bolts.

      Torque:
      71 N*m  { 724 kgf*cm, 52 ft.*lbf }

    5. Install the clamp with the bolt.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

  2. INSTALL NO. 2 FRONT EXHAUST PIPE SUB-ASSEMBLY


    1. A01DYY5

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum length
      40 mm (1.57 in.)

      If the length is less than the minimum, replace the compression spring.

    2. Install the No. 2 front pipe to the pipe support.

    3. A01E218E04

      Install a new gasket to the No. 2 front exhaust pipe.

      Tech Tips

      Using a plastic-faced hammer, uniformly strike the gasket so that the gasket and No. 2 front exhaust pipe are properly fit.

      Note


      • Be careful with the installation direction of the gasket.


      • Do not reuse the gasket.


      • To ensure a proper seal, do not use the front pipe to force the gasket onto the No. 2 front exhaust pipe.

    4. Install the No. 2 front pipe with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  3. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. Install the center pipe to the 3 pipe supports.

    2. Install a new gasket and the center pipe to the No. 2 front pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  4. INSTALL TAILPIPE ASSEMBLY


    1. Install the tailpipe to the pipe support.

    2. Install a new gasket and the tailpipe to the center pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }