AUTOMATIC TRANSAXLE SYSTEM MANUAL SHIFTING TEST

  1. PERFORM MANUAL SHIFTING TEST

    Tip:

    • Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

    • If any abnormalities are found in the following test, the problem is in the transaxle itself.

    1. C267931

      Disconnect the harness connector from the wiring harness connector.

      Tip:

      It is possible to deactivate the electrical shift control by disconnecting the harness connector. The gears can then be changed mechanically with the shift lever.

    2. Drive with the harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

      Shift Lever Position

      Gear

      P

      P

      R

      R

      D

      3rd

      No Shift (Gears will not change)

    3. Connect the connector of the harness connector.

    4. Clear the DTCs.

      Click here

      Powertrain > Engine and ECT > Clear DTCs