PARKING BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A005F17

      Install the parking brake control pedal assembly with the bolt and 2 nuts.

      Torque:
      15 N*m  { 148 kgf*cm, 11 ft.*lbf }
    2. A0059S1

      Connect the parking brake switch connector.

    3. Engage the wire harness clamp.

    4. A005AL1

      Install the No. 1 parking brake cable assembly with the 4 bolts and nut.

      Torque:
      15 N*m  { 148 kgf*cm, 11 ft.*lbf }

    5. Install the No. 1 parking brake cable assembly to the clamp.

    6. Engage the 2 wire harness clamps.

    7. A005DNZE03
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Temporarily install the lock nut.

      Tech Tips

      After adjusting parking brake pedal travel, tighten the lock nut.

  2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. A0059XLE02
      Text in Illustration
      *a Turn
      *b Hold

      Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. INSTALL YAW RATE AND ACCELERATION SENSOR

    Click here

  4. INSTALL AIR CONDITIONING UNIT ASSEMBLY

    Click here

  5. ADJUST PARKING BRAKE PEDAL TRAVEL

    Click here

  6. INSPECT BRAKE WARNING LIGHT

    Click here