EXHAUST PIPE INSTALLATION

PROCEDURE

  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    1. Check the free length of the compression spring.

      1. A128853

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length

        41.5 mm (1.63 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Install a new gasket to the exhaust manifold converter sub-assembly.

    3. Connect the front exhaust pipe assembly to the 3 exhaust pipe supports.

    4. Install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

      43 N*m

      438 kgf*cm

      32 ft.*lbf

  2. INSTALL FRONT FLOOR CENTER BRACE

    1. Install the front floor center brace with the 4 bolts.

      51 N*m

      520 kgf*cm

      38 ft.*lbf

  3. INSTALL NO. 2 ENGINE UNDER COVER

    1. Install the No. 2 engine under cover with the 4 clips.

  4. INSTALL TAILPIPE ASSEMBLY

    1. Check the free length of the compression spring.

      1. A128853

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length

        38.5 mm (1.52 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Install a new gasket to the front exhaust pipe assembly.

    3. Connect the tailpipe assembly to the 2 exhaust pipe supports.

    4. Install the tailpipe assembly with the 2 bolts and 2 compression springs.

      43 N*m

      438 kgf*cm

      32 ft.*lbf

  5. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.