AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM(except Sedan), Diagnostic DTC:B2424 and B2425
| DTC Code | DTC Name |
|---|---|
| B2424 | Headlight Leveling Motor LH Communication Malfunction |
| B2425 | Headlight Leveling Motor RH Communication Malfunction |
DESCRIPTION
The headlight swivel ECU assembly receives a signal from each headlight leveling motor using LIN communication.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
B2424 |
Headlight Leveling Motor LH Communication Malfunction |
|
|
B2425 |
Headlight Leveling Motor RH Communication Malfunction |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
If the headlight swivel ECU assembly has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight swivel ECU assembly.
PROCEDURE
CHECK FOR DTC
Clear the DTCs.
Body Electrical > AFS > Clear DTCs
Check for DTCs.
Body Electrical > AFS > Trouble Codes
OK
DTC B2424 and B2425 are not output.
Result
Proceed to
OK
NG
CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL ECU ASSEMBLY - HEADLIGHT ASSEMBLY)
Disconnect the A93 headlight swivel ECU assembly connector.
Disconnect the A163 headlight assembly LH connector or A162 headlight assembly RH connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Table 1. LH Side (DTC B2424) Tester Connection
Condition
Specified Condition
A93-30 (LHT) - A163-1 (LHM+)
Always
Below 1 Ω
A93-30 (LHT) - Body ground
Always
10 kΩ or higher
Table 2. RH Side (DTC B2425) Tester Connection
Condition
Specified Condition
A93-11 (RHT) - A162-1 (RHM+)
Always
Below 1 Ω
A93-11 (RHT) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE HEADLIGHT UNIT (HEADLIGHT LEVELING MOTOR)
Replace the headlight unit (headlight leveling motor) with a new or known good one.
Check for DTCs.
Body Electrical > AFS > Trouble Codes
OK
DTC B2424 and B2425 are not output.
Result
Proceed to
OK
NG
OK END (HEADLIGHT UNIT (HEADLIGHT LEVELING MOTOR) WAS DEFECTIVE)