WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED

Refer to the TOYOTA Repair Manual for each work procedure.

1. PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

   Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed
   Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes)	Stop and start system
   Memorize steering angle neutral point	Parking assist monitor system
   	Panoramic view monitor system
   Servo motor initialization	Air conditioning system
   w/ Power Back Door: Reset back door close position	Power back door function
   w/o Power Back Door: Power back door initialization	Power door lock control system

   Note

   After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

   Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

   System Name	See Procedure
   Vehicle enrolled in telematics system	6 minutes
   Vehicle not enrolled in telematics system	1 minute