CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)


    1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note

      If reusing the VVT sensor, be sure to inspect the O-ring.

    2. Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the VVT sensor connector.

  2. INSTALL VVT SENSOR (for Intake Side of Bank 2)


    1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note

      If reusing the VVT sensor, be sure to inspect the O-ring.

    2. Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the VVT sensor connector.

  3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)


    1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note

      If reusing the VVT sensor, be sure to inspect the O-ring.

    2. Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the VVT sensor connector.

  4. INSTALL VVT SENSOR (for Intake Side of Bank 1)


    1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note

      If reusing the VVT sensor, be sure to inspect the O-ring.

    2. Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the VVT sensor connector.

  5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  6. INSPECT FOR ENGINE OIL LEAK

    Click here