POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only) Power Windows do not Operate Using All Window Switch
| DTC Code | DTC Name |
|---|---|
| Power Windows do not Operate Using All Window Switch |
DESCRIPTION
The power windows operate by using the power window regulator master switch assembly or power window regulator switch assembly.
The power window regulator master switch assembly and power window regulator switch assembly connect the same power supply and ground lines.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH ASSEMBLY - BATTERY AND BODY GROUND)
Disconnect the H11*1 or G11*2 power window regulator master switch assembly connector.
*1: for LHD
*2: for RHD
Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage
Table 1. for LHD Tester Connection
Condition
Specified Condition
H11-15 (B) - Body ground
Ignition switch ON
11 to 14 V
Table 2. for RHD Tester Connection
Condition
Specified Condition
G11-15 (B) - Body ground
Ignition switch ON
11 to 14 V
Standard Resistance
Table 3. for LHD Tester Connection
Condition
Specified Condition
H11-7 (E) - Body ground
Always
Below 1 Ω
Table 4. for RHD Tester Connection
Condition
Specified Condition
G11-7 (E) - Body ground
Always
Below 1 Ω
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
Replace the power window regulator master switch assembly.
Result
Proceed to
NEXT
CHECK POWER WINDOW CONTROL SYSTEM
Check the operation of the power windows by using the power window regulator master switch assembly and power window regulator switch assembly.
OK
All power windows operate normally.
Result
Proceed to
OK
NG
OK END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE)