ROOF HEADLINING DISASSEMBLY

PROCEDURE

  1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY

    B227868

    1. Disconnect the connector.

    2. Detach the 4 claws and remove the No. 1 room light.

  2. REMOVE VANITY LIGHT ASSEMBLY

    B175184C08

    *1

    Claw (A)

    *2

    Claw (B)

    *3

    Bulb Holder
    Tip:

    Use the same procedure to remove the vanity light on the other side.

    1. Detach the 2 claws (A) and separate the bulb holder from the vanity light as shown in the illustration.

    2. Detach the claw (B) and remove the vanity light.

  3. REMOVE NO. 1 ROOF SILENCER PAD (w/o Roof Sunshade System)

    B222990

    1. Remove the 4 No. 1 roof silencer pads.

  4. REMOVE NO. 2 ROOF SILENCER PAD (w/o Roof Sunshade System)

    B222989

    1. Remove the No. 2 roof silencer pad.

  5. REMOVE NO. 2 ROOF HEADLINING PAD (w/ Roof Sunshade System)

    B227865

    1. Remove the 2 No. 2 roof headlining pads.

  6. REMOVE ROOF HEADLINING PAD

    B227866

    1. Remove the roof headlining pad.

  7. REMOVE ROOF HEADLINING PAD END

    B227867

    1. Remove the 2 roof headlining pad ends.

  8. REMOVE HEADLINING SUPPORT RETAINER

    B222991
    Tip:

    Use the same procedure to remove the headlining support retainer on the other side.

    1. Remove the headlining support retainer.

  9. REMOVE NO. 1 ROOF WIRE

    1. w/o Roof Sunshade System:

      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

        B461276C01

        *A

        w/o Pre-collision System

        *B

        w/ Pre-collision System

        *C

        w/ Rain Sensor, for LHD

        *D

        w/ Rain Sensor, for RHD

        *E

        w/ EC Mirror

        *F

        w/ Camera Heater

        *1

        Visor Connector

        -

        -
        V100155

        Tape

        		 V100144

        Butyl Tape

    2. w/ Roof Sunshade System:

      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

        B461277C01

        *A

        w/o Pre-collision System

        *B

        w/ Pre-collision System

        *C

        w/ Rain Sensor, for LHD

        *D

        w/ Rain Sensor, for RHD

        *E

        w/ EC Mirror

        *F

        w/ Camera Heater

        *1

        Visor Connector

        -

        -
        V100155

        Tape

        		 V100144

        Butyl Tape

  10. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here