WIRELESS DOOR LOCK CONTROL SYSTEM
| DTC Code | DTC Name |
|---|---|
| HOW TO PROCEED WITH TROUBLESHOOTING |
CAUTION / NOTICE / HINT
The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use these procedures to troubleshoot the wireless door lock control system.
*: Use the intelligent tester.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
Result
Result
NEXT
INSPECT BATTERY VOLTAGE
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Result
NEXT
CHECK FOR DTC*
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs.
Based on the DTCs output above, try to force output of the same CAN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.
Result
Result
Proceed to
DTC is not output
A
CAN communication system DTC is output
B
Wireless door lock control system DTC is output
C
PROBLEM SYMPTOMS TABLE
Refer to Problem Symptoms Table.
Result
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
B REPAIR OR REPLACEClick here
OVERALL ANALYSIS AND TROUBLESHOOTING*
Operation Check
Terminals of ECU
Data List / Active Test
Result
Result
NEXT
REPAIR OR REPLACE
Result
Result
NEXT
CONFIRMATION TEST
Result
Result
NEXT
NEXT END