STOP LIGHT SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  2. REMOVE COWL SIDE TRIM BOARD LH

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. for LHD:


      1. B0056Y3

        Disconnect the connector.

      2. B0057DCC04
        *a Lock Nut

        Loosen the lock nut.

      3. Turn the stop light switch assembly counterclockwise and remove it.

    2. B00583K

      for RHD:


      1. Disconnect the connector.

      2. Turn the stop light switch assembly counterclockwise and remove it.

  5. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER (for RHD)


    1. B005AT6C01
      B008HF7 Protective Tape

      Using a screwdriver, detach the 2 claws and remove the stop light switch mounting adjuster.

      Note

      The stop light switch mounting adjuster must not be reused.

      Tech Tips

      Tape the screwdriver tip before use.