CRUISE CONTROL SYSTEM(except 1ND-TV, 8NR-FTS) TC and CG Terminal Circuit

DTC Code DTC Name
TC and CG Terminal Circuit

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode.

WIRING DIAGRAM

E269391E27
E269391E28
E269391E24

CAUTION / NOTICE / HINT

Tip:

When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - ECM)

    1. Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)

      Table 1. for 1NR-FE, 1ZR-FE, 2ZR-FE

      Tester Connection

      Condition

      Specified Condition

      A50-23 (TC) - E11-13 (TC)

      Always

      Below 1 Ω
      Table 2. for 1ZR-FAE

      Tester Connection

      Condition

      Specified Condition

      A50-33 (TC) - E11-13 (TC)

      Always

      Below 1 Ω
      Table 3. for 1WW

      Tester Connection

      Condition

      Specified Condition

      A50-50 (TC) - E11-13 (TC)

      Always

      Below 1 Ω

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - ECM)

    OK

  2. CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND)

    1. E265513C03

      *a

      DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)

      Tester Connection

      Condition

      Specified Condition

      E11-4 (CG) - Body ground

      Always

      Below 1 Ω

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BODY GROUND)

    OK

  3. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND)

    1. E265513C04

      *a

      DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)

      Tester Connection

      Condition

      Specified Condition

      E11-13 (TC) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU