REAR DOOR LOCK INSTALLATION

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

    Click here

  3. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)

    Click here

  4. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

    Click here

  5. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

    Click here

  6. INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY (w/o Double Locking System)

    Click here

  7. INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

    Note


    • When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.


    1. Apply MP grease to the sliding parts of the rear door lock with motor assembly.

    2. When reusing the rear door lock with motor assembly:


      1. Install a new door lock wiring harness seal to the rear door lock with motor assembly.

    3. B005ZLDE06
      Text in Illustration
      *a Release Plate

      Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame sub-assembly, and set it to the rear door panel.

      Tech Tips

      Make sure that the release plate of the rear door outside handle frame sub-assembly is securely connected to the rear door lock with motor assembly

    4. Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  8. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  9. INSTALL REAR DOOR REAR GUIDE SEAL

    Click here

  10. CONNECT REAR DOOR WEATHERSTRIP


    1. Connect the rear door weatherstrip.

  11. INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

    Click here

  12. INSTALL REAR DOOR GLASS RUN

    Click here

  13. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  14. INSTALL REAR DOOR TRIM BRACKET

    Click here

  15. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  16. INSTALL REAR DOOR ARMREST COVER

    Click here

  17. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  18. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  20. INSTALL DECK FLOOR BOX RH

    Click here

  21. INSTALL REAR DECK FLOOR BOX

    Click here

  22. INSTALL NO. 1 DECK BOARD

    Click here

  23. INSTALL NO. 2 DECK BOARD

    Click here

  24. INSTALL DECK BOARD ASSEMBLY

    Click here

  25. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  26. INSPECT POWER WINDOW OPERATION

    Click here