REAR AIRBAG SENSOR(for 3 Door) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the side No. 2 airbag sensor assemblies.

PROCEDURE

  1. INSPECT SIDE NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

    1. Perform a diagnostic system check.

      Click here

  2. INSPECT SIDE NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

    1. Perform a diagnostic system check.

      Click here

    2. Visually check the side No. 2 airbag sensor assemblies for defects if a quarter panel of the vehicle or the area around a quarter panel is damaged.

      Tip:

      The defects are as follows:

      • Cracks on the sensor housing

      • Dents on the sensor housing

      • Chips on the sensor housing

      • Cracks or other damage to the connector

      • Damage to the serial number

      • Peeling of the label

      OK

      No defects are found.

      If any defects are found, replace the side No. 2 airbag sensor assembly with a new one.

  3. INSPECT SIDE NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)

    1. When airbags have deployed as the result of a collision, be sure to replace all side No. 2 airbag sensor assemblies in the damaged areas (anywhere in need of repair).

    2. Visually check the side No. 2 airbag sensor assemblies in undamaged areas for defects.

      Tip:

      The defects are as follows:

      • Cracks on the sensor housing

      • Dents on the sensor housing

      • Chips on the sensor housing

      • Cracks or other damage to the connector

      • Damage to the serial number

      • Peeling of the label

      OK

      No defects are found.

      If any defects are found or a side No. 2 airbag sensor assembly has detected a major collision, replace the side No. 2 airbag sensor assembly with a new one.