AUDIO AND VISUAL SYSTEM(w/o Multi-display), Diagnostic DTC:01-DC

DTC Code DTC Name
01-DC Transmission Error

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

01-DC

Transmission Error

Transmission to the component shown by the sub-code failed (Detecting this DTC does not always mean actual failure).

If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code
Tip:

This code may be stored if the engine is started and idled for 60 seconds and then the engine switch is turned to the start position again.

Note:

  • Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.

  • The radio receiver assembly is the master unit.

  • Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

CAUTION / NOTICE / HINT

Note:

Be sure to read Description before performing the following procedures.

PROCEDURE

  1. CHECK FOR DTC OF OTHER COMPONENTS

    1. Check if the component shown by the sub-code is displayed in the check result of the other components.

      1. Check if "01-DC" is output for the other components.

      2. If "01-DC" is output for any other components, check if the same physical address is displayed.

        Tip:

        For the list of the components shown by sub-codes, refer to the table in the next step.

        Result

        Result

        Proceed to

        "01-DC" is not output or the same physical address is not displayed

        A

        "01-DC" is output and the same physical address is displayed

        B
    B

    IDENTIFY COMPONENT WHICH HAS STORED THIS CODEClick here

    A

  2. CHECK FOR DTC

    1. Clear the DTCs.

      Click here

      Tip:

      If "01-DC" is output for only one component, this may not indicate a malfunction.

    2. Check for DTCs and check if the same trouble occurs again.

      OK

      The malfunction disappears.

      Result

      Result

      OK

      NG
    OK

    USE SIMULATION METHOD TO CHECK

    Click here

    NG

    CHECK COMPONENT WHICH HAS STORED THIS CODEClick here

  3. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE

    1. Enter the diagnostic mode.

      E146440N02

    2. Press the preset switch "channel 3" to change to "Detailed Information Mode".

    3. Identify the component which has stored this code.

      Component Table

      Component

      Physical Address

      Radio receiver assembly

      190

      Stereo component amplifier assembly

      440

      Multi-media interface ECU

      388
      Tip:

      • "440 (stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.

      • For details of the DTC display, refer to DTC Check/Clear.

        Click here

      Result

      Result

      NEXT
    NEXT

  4. CHECK COMPONENT WHICH HAS STORED THIS CODE

    1. Select the component which has stored this code.

      Component Table

      Component

      Proceed to

      Radio receiver assembly

      Radio receiver communication error

      Click here

      Stereo component amplifier assembly

      Stereo component amplifier communication error

      Click here

      Multi-media interface ECU

      Multi-media interface ECU communication error

      Click here

      Result

      Result

      NEXT
    NEXT

    END