СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ С ЭЛЕКТРОННЫМ УПРАВЛЕНИЕМ ПРОЦЕДУРА ПОИСКА НЕИСПРАВНОСТЕЙ

Tech Tips

The intelligent tester can be used at steps 3, 4, 6, and 9.


  1. Vehicle Brought to Workshop


    NEXT

  2. Customer Problem Analysis


    NEXT

  3. Connect the intelligent tester to DLC3


    NEXT

  4. Check and Clear DTC and Freeze Frame Data


    NEXT

  5. Visual Inspection


    NEXT

  6. Setting the Check Mode Diagnosis


    NEXT

  7. Problem Symptom Confirmation


    Symptom does not occur: Go to step 8

    Symptom occurs: Go to step 9

  8. Symptom Simulation


    NEXT

  9. DTC Check


    DTC is not output: Go to step 10

    DTC is output: Go to step 18

  10. Basic Inspection


    NG

    Go to step 20
    OK

  11. Mechanical System Test


    NG

    Go to step 17
    OK

  12. Hydraulic Test


    NG

    Go to step 17
    OK

  13. Manual Shifting Test


    NG

    Go to step 15
    OK

  14. Problem Symptoms Table Chapter 1


    NG

    Go to step 19
    OK

  15. Problem Symptoms Table Chapter 2


    NG

    Go to step 17
    OK

  16. Problem Symptoms Table Chapter 3


    NEXT

  17. Part Inspection


    Go to step 20

  18. DTC Chart


    NEXT

  19. Circuit Inspection


    NEXT

  20. Repair or Replace


    NEXT

  21. Confirmation Test


    NEXT
    End