POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B006A1V

      Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH to the front door window regulator sub-assembly LH with the 3 "TORX" screws.

      Tech Tips

      A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY LH

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. INSPECT FITTING OF FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. CHECK SRS WARNING LIGHT

    Click here

  8. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  9. INSPECT POWER WINDOW OPERATION

    Click here

  10. INSPECT DOOR LOCK OPERATION

    Click here