MANUAL TRANSAXLE ASSEMBLY(When Not Using the Engine Support Bridge) COMPONENTS
ILLUSTRATION
| *1 | CONTROL CABLE BRACKET ASSEMBLY | *2 | ENGINE MOUNTING BRACKET LH |
| *3 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *4 | NO. 1 HEATER BRACKET SUB-ASSEMBLY |
| *5 | NO. 2 ENGINE MOVING CONTROL ROD | *6 | WIRE HARNESS |
| *7 | WIRE HARNESS CLAMP BRACKET | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY | *2 | MANIFOLD SUPPORT BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BLEEDER CLUTCH RELEASE TUBE | *2 | CLUTCH FLEXIBLE HOSE BRACKET |
| *3 | CLUTCH RELEASE BLEEDER SUB-ASSEMBLY | *4 | CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE |
| *5 | CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY | *6 | MANUAL TRANSAXLE ASSEMBLY |
| *7 | SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY | *8 | O-RING |
| *9 | CLUTCH TUBE BOOT | *10 | FLYWHEEL HOUSING SIDE COVER |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with union nut wrench | ● | Non-reusable part |
 |
Clutch spline grease |  |
Gear oil |
| ★ | Precoated part | *T1 | for Flange Bolt: 37 (377, 27) for Bolt with Washer: 33 (337, 24) |