NOISE FILTER ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT RADIO SETTING CONDENSER


    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. B008L4OC05
      *a Radio Setting Condenser

      Measure the resistance of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Ignition switch off

      • High mounted stop light off

      • Window defogger off

      		 Below 1 Ω

    3. Remove the bolt.

    4. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    5. B008LZLC29
      *a Radio Setting Condenser

      Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      • Ignition switch off

      • High mounted stop light off

      • Window defogger off

      		 10 kΩ or higher
      1 - 3 10 kΩ or higher
      Standard Voltage
      Tester Connection Condition Specified Condition
      2 - Body ground

      • Ignition switch ON

      • Window defogger off

      		 Below 1 V
      3 - Body ground

      • Ignition switch ON

      • High mounted stop light off

      		 Below 1 V
      2 - Body ground

      • Ignition switch ON

      • Window defogger on

      		 11 to 14 V
      3 - Body ground

      • Ignition switch ON

      • High mounted stop light on

      		 11 to 14 V