TELEMATICS SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Telematics / Data List.

    5. According to the display on the GTS, read the "Data List".

      Body Electrical > Telematics > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      VIN

      VIN registered to the telematics transceiver

      17 digits

      Vehicle VIN displayed

      -

      Unsent Emergency Call Number

      Number of times an emergency call has failed

      Min.: 0, Max.: 255

      0

      -

      Activation Status

      Telematics transceiver activation status

      Shipping(Disable), Shipping(Enable), Full Services, Full Services & F&I Service, eCall only

      eCall only

      -

      Backup Battery Status

      Mobilephone battery replacement flag

      Normal or Replace

      Normal

      -

      Number of Trouble Codes

      The number of the DTC which is currently output

      Min.: 0, Max.: 255

      Number of stored DTCs displayed

      -
  2. Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    ACTIVE TEST

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Telematics / Active Test.

    5. According to the display on the GTS, perform the Active Test.

      Body Electrical > Telematics > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Beep

      Operate front No. 1 speaker assembly RH and front No.2 speaker assembly RH

      OFF, ON

      -

      Body Electrical > Telematics > Active Test

      Tester Display

      Beep