HORN INSTALLATION

PROCEDURE


  1. INSTALL LOW PITCHED HORN ASSEMBLY


    1. B008GDIC02
      *A Type A
      *B Type B

      Install the low pitched horn assembly with the bolt.

      Torque:
      for Type A
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }
      for Type B
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

      Note

      There are two types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

    2. Connect the connector.

  2. INSTALL HIGH PITCHED HORN ASSEMBLY


    1. B008GDIC02
      *A Type A
      *B Type B

      Install the high pitched horn assembly with the bolt.

      Torque:
      for Type A
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }
      for Type B
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

      Note

      There are two types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

    2. Connect the connector.

  3. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  4. INSTALL ENGINE ROOM SIDE COVER

    Click here