NAME PLATE INSTALLATION

CAUTION / NOTICE / HINT

Tip:

When installing the name plate or emblem, heat the vehicle body and name plate or emblem using a heat light.

Table 1. Heating Temperature
Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Name Plate or Emblem	20 to 30°C (68 to 86°F)

Note:

Do not heat the vehicle body, name plate or emblem excessively.

PROCEDURE

INSTALL NO. 2 BACK DOOR NAME PLATE

Clean the vehicle body surface.
1. Using a heat light, heat the vehicle body surface.
2. Remove any double-sided tape from the vehicle body.
3. Wipe off any tape adhesive residue with cleaner.

Install a new No. 2 back door name plate.

Using a heat light, heat the vehicle body and No. 2 back door name plate.
Remove the release paper from the No. 2 back door name plate.

Tip:
After removing the release paper, keep the exposed adhesive free from foreign matter.

Install the No. 2 back door name plate as shown in the illustration.

*a	Profile of Back Door Glass Sub-assembly	-	-

Standard Measurement


Area	Measurement	Area	Measurement
A	136.9 to 138.9 mm (5.39 to 5.47 in.)	B	134.7 to 136.7 mm (5.30 to 5.38 in.)
C	15.6 to 17.6 mm (0.614 to 0.693 in.)	-	-

INSTALL NO. 1 BACK DOOR NAME PLATE

Clean the vehicle body surface.
1. Using a heat light, heat the vehicle body surface.
2. Remove any double-sided tape from the vehicle body.
3. Wipe off any tape adhesive residue with cleaner.

Install a new No. 1 back door name plate.

Using a heat light, heat the vehicle body and No. 1 back door name plate.
Remove the release paper from the No. 1 back door name plate.

Tip:
After removing the release paper, keep the exposed adhesive free from foreign matter.

Install the No. 1 back door name plate as shown in the illustration.

*a	Profile of Back Door Glass Sub-assembly	*b	Center Line of Back Door Glass Sub-assembly

Standard Measurement


Area	Measurement	Area	Measurement
A	100.6 to 102.6 mm (3.96 to 4.04 in.)	-	-