WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

  • Ensure that the headlight assembly is not damaged.


  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


    1. A0050F1

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.

    2. A0050IC

      Install the upper headlight protector retainer with the 2 screws.

  2. INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER


    1. A0050KK

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note

      After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.

    2. A0050EZ

      Install the upper No. 2 headlight protector retainer with the 2 screws.

  3. REMOVE UPPER HEADLIGHT PROTECTOR RETAINER LH


    1. A0050FS

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note

      After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.

    2. A0050KC

      Install the upper headlight protector retainer LH with the 2 screws.

  4. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER


    1. A0050GW

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note

      After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.

    2. A0050HJ

      Install the lower headlight protector retainer with the 2 screws.

  5. INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER


    1. A0050D9

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note

      After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.

    2. A0050MF

      Install the lower No. 2 headlight protector retainer with the 2 screws.